How to Download Logos to Polar CS100, CS200 and CS300 Cycling Computers

To transfer a logo, you need to have loudspeakers and a sound card in your computer.


1. Depending on your cycling computer, select one of the following:

CS100: In Time mode, press the Right button until SETTINGS is displayed. Place the cycling computer less than 10 cm/ 4" from the loudspeaker and do not move it during the data transfer.

CS200: In Time mode, press the Right button until CONNECT is displayed. Press the Middle button and select Receive DATA. Place the cycling computer less than 10 cm/ 4" from the loudspeaker and do not move it during the data transfer.

CS300: In Time mode, press the Up button until CONNECT is displayed. Press Start/Ok and select RECEIVE. Press Start/Ok again and UpLink is displayed. Place the cycling computer less than 10 cm/ 4" from the loudspeaker and do not move it during the data transfer.

2. Select the logo you wish to transfer to your cycling computer and click ‘Download’. Your cycling computer automatically starts to upload the information. You will hear a chirping sound during information transfer. UpLink and a line of moving dots are displayed on the upper row.

3. Logo transfer is ready when the chirping sound ceases and OK is displayed on the upper row.

4. Press and hold the Left button to return to Time display.

5. To activate the new logo, press and hold the Right button in Time mode.

If the data transfer failed, check that you:
- bring the cycling computer closer to the loudspeaker.
- turn the volume level of the loudspeakers up.
- do not to wear the transmitter during logo transfer.

Was this helpful? Yes No